Aires acondicionados Dometic Penguin II

Filtrar:

Precio
El precio más alto es $2,499.99 Restablecer
$
$
Tipo de producto
0 seleccionados Restablecer
Marca
0 seleccionados Restablecer

5 productos

The Dometic Penguin II is a popular rooftop air conditioner found on a wide range of RVs, known for its low-profile design and reliable cooling performance. When an existing unit stops cooling effectively or fails altogether, a direct replacement is often the most practical solution for getting your RV comfortable again.

Penguin II units are available in 13,500 BTU and 15,000 BTU configurations to suit different RV sizes and cooling needs. Many models are also compatible with Dometic's single zone thermostat controls for added convenience. Check your current unit's BTU rating and roof opening dimensions before ordering to confirm the replacement is the correct fit for your RV.

What is the Dometic Penguin II and how is it different from the original Penguin?

The Penguin II is Dometic's low-profile rooftop RV air conditioner, designed with a sleeker aerodynamic shroud that sits about 9.75 inches above the roofline to reduce drag and clearance issues. Compared to the original Penguin, the Penguin II uses an updated motor and fan assembly for quieter operation and is available in 13,500 BTU and 15,000 BTU cooling capacities, with optional heat pump models for shoulder-season use. It fits standard 14" x 14" RV roof openings.

Does the Penguin II come with a heat pump option?

Yes. The 15,000 BTU Penguin II is available as a heat pump model, which reverses the refrigeration cycle to provide supplemental heat down to roughly 40°F outside temperature. Below that, you will need your furnace or LP heat. The heat pump unit draws AC power only, so you do not need an LP gas connection at the rooftop. Confirm your thermostat is heat-pump compatible before ordering.

What ceiling assembly do I need to install a Penguin II?

The Penguin II rooftop unit ships separately from the ceiling assembly, and the assembly you choose depends on whether your RV has ducted or non-ducted air distribution and whether you use a wall or ceiling thermostat. For non-ducted setups with a wall thermostat, see our Dometic ceiling assembly for non-ducted installations. Confirm your RV's duct configuration before ordering.

What amp draw and power source does the Penguin II need?

The 15,000 BTU Penguin II runs on 115V AC and pulls roughly 13-16 amps under load, depending on ambient temperature and compressor cycle. A 30-amp shore power connection handles one Penguin II with normal accessory use; running two units typically requires 50-amp service or a soft start kit to manage inrush current. For shore power adapters and dogbones, see our RV plug adapters collection.

Will the Penguin II fit my existing 14" x 14" roof opening?

Yes, the Penguin II is built for the standard 14" x 14" RV roof cutout used by virtually all factory-installed rooftop air conditioners, so it drops in as a direct replacement for most Coleman, older Dometic, and Atwood units. The rooftop gasket and mounting hardware are included with the unit. Always confirm your roof thickness falls within the 1.75" to 5.5" range supported by the included bolt kit before installing.