Sellos deslizables

What types of RV slide-out seals are there?

RV slide-outs use three main seal profiles. Wiper seals (also called sweep seals) are the long, flexible blades that ride against the slide wall as it extends and retracts, blocking dirt, rain, and pests. D-seals are hollow bulb gaskets shaped like the letter D that compress against the slide when it's closed, creating the primary weather barrier. Bulb and ribbed seals sit on the slide perimeter to seal against the sidewall opening. Most rigs use a combination of all three, and replacing them as a set gives the best result.

How do I know which RV wiper seal fits my slide?

Measure three things before ordering: the height of the wiper blade (from the mounting base to the tip), the width of the mounting base, and the total length needed per slide opening. Many wiper seals also have a specific mounting style, screw-on, push-in, or adhesive backed, so confirm how your existing seal attaches to the slide box. Heartland, Keystone, Forest River, and Jayco use different profiles, so matching the original part number or sending a cross-section photo is the safest path. If you need help confirming fitment, text or call 817-984-1852.

How much does RV slide-out seal replacement cost?

Seal material itself typically runs $4 to $12 per linear foot depending on profile (wiper, D-seal, or bulb), so a single slide usually takes $60 to $200 in parts. A full coach with three or four slides can run $300 to $700 in seals. Shop labor at an RV dealer adds $400 to $1,200 per slide, which is why most owners on this collection do the swap themselves. The job needs a putty knife, rubbing alcohol, butyl tape or 3M adhesive, and a few hours per slide.

What other parts should I replace at the same time?

When the slide is pulled and the seals are off, it's the right moment to inspect adjacent systems. Re-seal any roof seams or screw heads near the slide opening with butyl or self-leveling sealant, and check the roof vents while you're up there: our Ventline vent accessories cover the most common replacement parts. If you're tackling seal work before storage season, pair the job with a winterizing kit to protect the plumbing at the same time. For interior trim or electrical that gets disturbed during the swap, browse RV electronics for replacement switches and connectors.

How long do RV slide-out seals last?

EPDM rubber slide seals typically last 5 to 10 years depending on UV exposure, climate, and how often the slide cycles. Full-time rigs parked in Arizona or Florida sun see seals crack and harden faster, sometimes in 3 to 5 years. Signs it's time to replace include visible cracking, hardening, gaps when the slide is closed, water staining on the interior trim, or wiper blades that have taken a permanent set and no longer sweep flat against the slide wall.

Can I replace a Heartland slide wiper seal myself?

Yes. Heartland slide wiper seals are screw-mounted on most models, which makes the job straightforward with hand tools. Retract the slide fully, remove the trim screws holding the old wiper, peel the seal off, clean the mounting surface with rubbing alcohol, and install the new seal working from one end to the other so it sits flat. Apply a thin bead of butyl tape behind the mounting flange before driving the screws back in to keep water out of the screw holes. Plan on 45 to 90 minutes per slide.

Do you carry D-seals for RV slide-outs?

Yes. This collection includes D-seals in the common profiles used on Keystone, Heartland, Forest River, Jayco, and Grand Design slide-outs, sold by the foot and in pre-cut kits. D-seals compress against the slide face when it's retracted, so the bulb diameter and mounting base width need to match your original, an oversized bulb will prevent the slide from seating flush, and an undersized bulb will leak. Confirm the original part number on your rig or measure the existing seal cross-section before ordering.