Conjunto de techo Dometic Brisk II para instalaciones de zona única

What is included in a Dometic Brisk II single zone ceiling assembly?

A single zone ceiling assembly is the interior-side kit that pairs with a Brisk II rooftop unit for non-ducted installations. It typically includes the ceiling grille, return air filter, control board, wiring harness, and the Dometic Brisk Air 2 thermostat interface. Single zone means one thermostat controls one AC unit, with no zone dampers or multi-unit logic. Always confirm whether your rooftop unit is heat pump or cool-only before ordering, since the ceiling assembly must match.

How do I know if I need a single zone or multi-zone ceiling assembly?

Count the rooftop AC units on your RV and check whether one thermostat runs the whole coach or separate thermostats run the front and rear units. One AC, one thermostat means single zone, this collection is the right fit. Two or more units sharing a CCC2 thermostat means multi-zone, which uses a different control board and harness. Look at your existing thermostat model number to verify before ordering.

Is this ceiling assembly compatible with the Dometic FreshJet or Coleman Mach?

No. The Brisk II single zone ceiling assembly is engineered specifically for Dometic Brisk II rooftop units in non-ducted configurations. FreshJet units use a different ceiling kit, see the FreshJet 5 with Heat Pump ceiling assembly for non-ducted installations. Coleman ducted systems use their own assembly, see the Coleman Power Saver HP ceiling assembly for ducted installations.

Can I add a soft start kit when replacing my ceiling assembly?

Yes, and the ceiling assembly swap is a good time to do it. A soft start reduces inrush current at compressor startup, which lets the Brisk II run on a 30 amp pedestal with other loads active or start on a properly sized inverter. See the Coleman RV air conditioner soft start collection for compatible options. The soft start mounts at the rooftop unit, not the ceiling assembly, so the two installs are independent.

How difficult is the ceiling assembly installation?

Most owners can complete the swap in about an hour with basic hand tools. The job involves dropping the existing grille, disconnecting the thermostat wiring and control board harness, and reversing the process with the new assembly. Shut off shore power and battery disconnect before starting. If your replacement uses a different control board revision than the original, label your wires before disconnecting. Text or call 817-984-1852 if you need to confirm wiring before you order.

What shipping options are available on these ceiling assemblies?

Ceiling assemblies ship via standard ground carrier, no truck freight required. Orders over $100 ship free. In-stock items typically leave the warehouse within one to two business days. Confirm your model number against the product listing before ordering to avoid return shipping on the wrong assembly.